Kepco MST 488 Programmer Manual de usuario descargar pdf (Pagina 67)

MST 488 SVC 013004

C-5

FIGURE C-8. STA — STATUS COMMAND

Syntax: STA

Function: Causes power supply to return operating status to controller.

Description:

This operator commands the power supply to report its present operating status. Status is reported in

the form of a message (character string) as defined below. Any catastrophic error conditions (indicated

by * in the table below) which exist will be reported, until the error condition is corrected. As required

by CIIL, all error messages begin with an ASCII “F” (Fault) followed by a 2 digit code, “07” (Halt). The

code that follows (SCSnn) indicates the type of device and the channel number. The next 3 digit code

describes the nature of the fault: “DEV” for device related errors or “MOD” for non-device errors, such

as syntax.

TABLE C-2. CIIL ERROR MESSAGES

ERROR MESSAGE EXPLANATION

F07 DCSnn DEV Power Loss

The power supply has lost its input power. *

F07 DCSnn DEV Crowbarred

(MAT, MBT) A shutdown occurred due to overvoltage or overcurrent. *

F07 DCSnn DEV Device Turned Off (BOP)

F07 DCSnn DEV Output Fault (MST)

F07 DCSnn DEV Over Temperature

A shutdown occurred due to thermal causes. *

F07 DCSnn DEV Overload

The voltage or current limit point was exceeded. *

F07 DCSnn DEV Voltage Fault

The output voltage is not within limits (voltage mode). *

F07 DCSnn DEV Current Fault

The output current is not within limits (current mode). *

F07 DCSnn DEV Relay Not Opened

The power relay failed to open. *

F07 DCSnn DEV Relay Not Closed

The power relay failed to close. *

F07 DCSnn DEV Polarity Error

The output polarity is not correct. *

F07 DCSnn DEV

Load Path Fault Open or miswired load or error sense leads detected. *

F07 DCSnn MOD Invalid Command

Improper syntax was used. **

F07 DCSnn DEV Not Ready

The output voltage or current has not settled. **

F07 DCSnn DEV Device Not Present

The specified power supply was not present during power up or

during the last DCL. **

F07 DCSnn DEV Device Not Responding

The power supply has failed to communicate to the controller.

F07 DCSnn DEV Invalid Voltage Range

The programmed voltage is outside the power supply's range.

F07 DCSnn DEV Invalid Current Range

The programmed current is outside the power supply's range.

F07 DCSnn DEV Set Modifier Error

An improper SET command was sent. **

F07 DCSnn DEV Invalid Device ID

The selected channel was not between 1-31. **

*Catastrophic error

**Non-Catastrophic error

STA

1 2 ... 62 63 64 65 66 67 68

Comentarios a estos manuales

Sin comentarios

Kepco MST 488 Programmer Manual de usuario Pagina 67

Comentarios a estos manuales

Relacionado con productos y manuales para Proveedores De Energía Kepco MST 488 Programmer