Kepco KLR Series Developers Guide Manual de usuario descargar pdf (Pagina 54)

4-12 KLR-DEV 060713

4.6.2 SOFTWARE TIMED RAMP EXAMPLE

When the Software Ramp button on the front panel is depressed, the panel shown in Figure 4-8

is displayed. The figure illustrates a current ramp; the voltage ramp panel is similar. The {Power

Supply Mode switch on the front panel (Figure 4-7) determines whether the current ramp or volt-

age ramp is displayed. It is also possible to run this program by selecting either:

KepcoDCPwr Software Timed Ramp Example.vi for a voltage ramp

KepcoDCPwr Current Software Timed Ramp Example.vi for a current ramp.

FIGURE 4-8. SOFTWARE RAMP PANEL, CURRENT RAMP EXAMPLE

These files are located in the kepco DcPWr folder created when the Kepco LabView G driver is

installed and can be executed by selecting File > Run from within LabView. When invoking

either of these files directly, either a network address or a GPIB address must be set before

clicking Start Ramp (this is automatic when executing Software Ramp via the Front Panel.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 127 128

Sin comentarios

Kepco KLR Series Developers Guide Manual de usuario Pagina 54