Kepco KLR Series Developers Guide Manual de usuario descargar pdf (Pagina 68)

5-6 KLR-DEV 060713

FIGURE 5-2. EXAMPLE 2: USING THE POWER SUPPLY TO CREATE A VOLTAGE RAMP (SHEET 2 OF 2)

Kpklr_Set_Volt_Curr (KLR_Session, voltage, current); //voltage and current

The above function sets both the voltage and current setpoint of the power supply

Kpklr_OutputOnOff ( KLR_Session, 1); // output on

for (i=0;i<10;i++){ // generates the ramp ten times

for (voltage-voltage_start; voltage <=voltage_end; voltage+=voltage_change){

Kpklr_SetValue (KLR_Session, voltage,0); // set the voltage level only

Delay(500); // delay for 500 milliseconds

}

Kpklr_SetValue (KLR_Session, voltage_start,0); // set the voltage level only

delay (1000); // wait for unit to return to zero (no load)

} // end of all ramps

Kpklr_OutputOnOff ( KLR_Session, 0); // output off

Kpklr_close( KLR_Session); // free up memory and close VISA session

return (power_supply_status);

} // end of main

// if not created as a project, include the driver code at end of program

#include "Kp_KLR.c"

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 127 128

Sin comentarios

Kepco KLR Series Developers Guide Manual de usuario Pagina 68